Hi ! Here is the story ---(x-5,2003 ) Windshield was replaced ....and it is not original german one ! Plastic holders for rain sensor ( basic ones- implanted inside windshild inside car behind rear view mirror) -- are broken during instalation - left side small plastic teth,( some qualified psudo-pro ets did some damage..) A very tighny little peaces of this sensor slightly dammeged ( plastic outside sensor? but not sensor itself !)..It's complicated< but pause electronic device interfiering with this electronic sensor and ... do NOT work as pause usually works.. ( it doesnot work at all on automatic mode with this rain sensor ..most probably there is no proper contact between this sensor and windshield) ,please do not smile....-- without this sensor...Thats meen I remooved one ...and pause mechanizm finally works(!!!)- as normal one !but ...autolamp does not funcsioning at all ( manual onle version !) As the negative result of removal of this rain sensor !
Plan is ...demontage it myself.. perhaps cut and sharpen with abrasive send paper plastic litle uneven teeth ..then varify corelationship between this sensor and glass manually , then, if any sucsess ..my plan is...- to put on epoxy- glue or...---here is the question: - Did anybody had this problems and possibly can shere expirience and results with me ?? [email protected]
Regards Johnni dec20,05