View Single Post
  #8  
Old 05-12-2010, 06:42 AM
anderdr anderdr is offline
Member
 
Join Date: Aug 2009
Location: Norway
Posts: 12
anderdr is on a distinguished road
I am not able to get the MKIV to start, I have tried connecting both +12v and ground to case + the ground pins on the back of it.

In navcoder I get:
ready - idle
idle 1sec
recieving bus message - busy

But that only indicates that the IBUS "controller" in the navi is alive, right?

and that goes in a loop, not able to start it with +12 on ignition pin, and no response from navi device in navcoder. I have no clue about writing IBUS commands myself, but maybe that was what I needed to do, to make it wake up?
Reply With Quote

Sponsored Links