Quote:
Originally Posted by powers1
Nice job lebahawk.Did you use the B90 tool afterall?What was the hardest thing you found when replacing the hub/bearing?
Thanks for the input  |
I was planning on using it but I couldn't find a store where I can rent one... so I end up using the slide hammer that i rent it from Auto zone to pull the hub from the old bearing, and I used the universal bearing puller discs that I also bought from harbor freight to pull the old bearing and install the new one.... the tough part was re-installing the axle back into the hub it was pain it took lots of hammering on a 2x4 block! but I had to hammer it enough so i would be able to install the axle nut back on. It wasn't that bad over all but you need to have some patience as your doing it.