Quote:
Originally Posted by ccfj1
I don't know what the colours are mate,
But the output from the phone should be (if you have a bm54), 6 and 12 (+ and -).
If you have a bm24 then it's pins 8 and 3 (+ and -).
There is only 1 mute and its pin10 on a quadlock (bm54) and pin 7 on the 17 round pin (bm24 radio).
You will also need the "tel-on", this is a must as it does some fancy switching in the radio module.
On the quadlock (bm54), its pin 11 on the 17 round pin (bm24) its 10.
The phones 54pin plug is as follows:
MUTE----------------------PIN 51 ULF
+12 V Direct-------------PIN 17 ULF
+12 V Switched--------PIN 35 ULF
I-BUS --------------------PIN 15 ULF
TEL ON-------------------PIN 33 ULF
GND----------------------PIN 36 ULF
Pairing switch------------PIN 32 ULF
Audio Tel + -------------PIN 37 ULF
Audio Tel - --------------PIN 38 ULF
1: MIC + -----------------PIN 1 ULF
2: MIC - ------------------PIN 19 ULF
3: MIC Shield------------PIN 21 ULF
|
Thanks for the information.. yes it is a BM54.
Well I found two issues after your information came and finding the correct colors from WDS (finally got that to wrok).
The Telephone Audio and MUTE (both of them, well one mute, one telon) pins in the Quadlock were in the wrong place. So I fixed them but had no affect, but then realised the wires were tied together on the radio plug and didnt go back to the main black plug. On the main black plug, I found the Phone AUDIO wires didnt goto the radio module either.
The short story is I fixed the cabling from the black plug (12 pin that supplies power to the harness and plugs near the NAV unit) and then the phone worked.
With regard to the NAV, those pins were in the wrong place. Put them in the right place on the quadlock, and everything now works.
Thanks again,
Rob