Quote:
Originally Posted by dirtymonkey29
Just been looking at your picture of the splitter you made in the below thread
http://www.xoutpost.com/electronics/...interface.html
Im assuming the female connecter is the larger connector that houses the 3 male terminals. and there is two wires connected to each terminal in the female block? |
Correct.
Quote:
|
Are these all push fit connectors? or do the wires need soldering?
|
The connectors are push fit but I had to solder the leads together.
Quote:
Originally Posted by dirtymonkey29
also what thickness/guage wire did you use?
|
Don't know, it came with the pins attached, so I used that.
Quote:
Originally Posted by dirtymonkey29
also, i will need a connector on the other end of my usb interface to plug onto one of the male connector blocks.....will i need 2 female connector blocks or is it a different plug that fits into the male connector?
|
1) 61.13.8.377.072 - Male Plug x2 - same as CD I-bus plug. = £0.68
2) 61.13.0.006.663 - Female termination x6 = £0.90
3) 61.13.6.931.929 - Female plug x1 = £0.98
4) 61.13.0.006.664 - Male termination x3 = £0.94
__________________
Sept 03, M3, Silver Grey. Retro-fits: Modded Mk4 DVD Drive, OEM Bluetooth, VR Control, Rainbow Speaker Upgrade, Sony SOT Amp, HK Sub, CCFL, Intravee II, NightMode.
|