Quote:
Originally Posted by ard
1. You actually don't have a 'gas cap'.
2. Post the codes. Make sure they READ and report the code and not just clear it then look.
3. Minimize TOE on the alignment..don't just go with something within the "BMW specs".
A
|
1. Really? Pretty nitpicky, Ard, even for you.
2. Good point. They will get very specific instructions to print and provide a copy of the OBD results.
3. I always have them set the toe as close to 0,00 as possible, within spec. I believe this is 0,02'. They will not set it out of spec, but 0,02' is sufficient to eliminate outside edge wear, unless camber starts to drift toward the + side.