View Single Post
  #6  
Old 01-15-2012, 06:44 PM
brptrailrider brptrailrider is offline
Member
 
Join Date: Jun 2011
Location: USA
Posts: 66
brptrailrider is on a distinguished road
Fixed it!!!

In case anyone runs into this problem this is what I did.

I removed the bolts on the right side regulator and right side window clip bolt (closer to the rear of the car) and wedged it out of the door. Then I rotated it 180 degrees top towards me. This caused the cables to switch positions. Now the cable going from the motor to the top right guide is closer to the door panel and the cable going from the top left guide to the bottom right guide is closer to the door skin (outside of the car) where they overlap. I also put a loose zip tie on them like the OEM regulator so it wouldn't make a noise bouncing around when the door is closed. After this is started working at regular speed!!!

But it was still making a creaking noise just before fully closing and opening. Turns out it was the plastic guides on the big cable springs by the motor. Tried silicone and lots of other lubes but it still made noise. Put a gob of white lithium grease on it and it stopped making the creaking noise.

Time to put the panel back on.

This regulator had obviously been replaced before since some of the door panel clips were missing.
Reply With Quote

Sponsored Links