Will be installing new bleeder screw - make sure its on not too tight and then leave the expansion tank open and start the engine with the normal procedures - saw this video also so will follow through and hopefully its nothing else.
Bleeding the air out.wmv - YouTube
I was concerned about driving with it overheating but I had pulled over immediately as soon as the warnings came on and I noticed it going into red. While crawling back I only drove about a half a mile before it would go up to red and let it cool at least 5-10 minutes in between and at times more wherever it was safe to pull over. I hope there is no engine damage as it seemed to be running fine when i took it for a test drive around the block.
Once this is done I am going to the local Autozone to get a read out and will post the findings here. Was hoping to drive it over to New York once this is done but I want to make sure its proper before I take a risk.
thanks again