Quote:
Originally Posted by roryhinds
Thanks for the help, I can't tell enough how much I appreciate it.
How would I check the output from the new alternator?
How do I recalibrate the EHC module to recognise the new sensor?
In INPA I go into the 2 axel suspension and check the errors there and it says... left front level sensor gives a hardware error.
And in the Central Body Electronics I'm seeing the
144 Clamp 15
Error frequency : 33
Open circuit
Sporadic error
|
+1 on checking the height sensor elbow orientation as Terminator points out..... I had the same issue, had the elbow pointing inward towards the engine after changing the wishbone. Changed it to point out towards the wheel and all is good! Check the wires going up and out of the sensor for insulation wear exposing wires and a possible short?
Relcalibrating/ resetting the EHC module is a last resort and you will probably need a GT1 or SSS/ progman interface software package to perform calibrations and adjustments if needed.
__________________
"I can’t understand it. I can’t even understand the people who can understand it"
Queen Juliana (1909-2004), of the Netherlands
"If you choose not to decide, you still have made a choice!"
2004 X5 4.8is Imola Red-228K ZF-GA6HP26Z-Sold
2006 X3 3.0i Mystic Blue-175K, ///M pkg 6-Spd Manual- Trading in 6/10/17 for a Mini too!
2003 Silver X5 3.0- sold
2000 VW Beetle 1.8 turbo-165K- Totaled 9/11/16
|