View Single Post
  #5  
Old 06-13-2013, 01:15 PM
Mackskibum Mackskibum is offline
Member
 
Join Date: Jan 2006
Location: Eastern PA
Posts: 253
Mackskibum is on a distinguished road
Lubehead,

I agree the tube should not be necessary. Unfortunately with the design of some rim clamp tire machines, there is not enough freeboard between the bottom of the rim and the machine table to set the inside bead by pushing down on the tire. In a normal situation, the installer sets the inside bead and then lifts the tire so that the outside bead touches the rim while inflating the tire and it will "catch". I have had tires where the strap around the middle wouldn't close the gap- the tire would buckle before the bead spread far enough- hence the bicycle tube. There are also air tanks available with a large hole and flexible nozzle that can be used to set a bead- (the other option (ether and a match) is dangerous and should never be attempted)

My point was that there are other ways to get the bead to set- that the rim design is not a limiting factor in being able to use a regular vs. run flat tire.
__________________
Dave

'05 325xi
'10 E70 35d
'85 911 Carrera
'66 911 Work in progress
'91 Chevy C1500
'95 Jeep Cherokee
‘18 Jeep JLU
Reply With Quote

Sponsored Links