My blower went dead in the morning and suddenly worked flawlessly towards the afternoon. Ordinarily I would let it be for a while but with the heat I had to get a move on

so I got around to removing the FSU. 3 minutes to remove the panel and get to it and another 15minutes trying to remove the socket. and after about 30 minutes carefully removing the insulation I get around to solder it. its not my best work, but it will have to do





so after plugging it back in of course it worked. but now as I write this I just realized I didnt put any form of silicon or gasket maker in to cavity. Is this a necessary step or can it be left as is? I did cover it with electrical tape but I didnt give it much thought till now