Yep, thank you forum for this info. It took me much longer as I struggled to get the inner door panel off not wanting to break anything. The top part didn't want to budge so I thought there was an additional fastener but nope those clips on top were just extremely stubborn but with a huge pull up/tug it finally broke free. Outside the blank cap was a PITA to remove and so was the non-lock piece underneath. I put tape all over to protect the paint but still ended up with tiny nicks. Crazy rubik's cube project.

I didn't know how to unclip the inner lever cable so just unbolted the assembly and levered it out through the hole in the panel keeping everything attached. I found the fiber optic cable was installed too but it broke off and the cable so short - someday will extend it to make r&r easier and reattach to the cup. Was so dim it barely lit up the cup anyways, without the "light pipe" was so much brighter. For now duct taped it to the cup best I could but the angle is off.

Also working by myself for the reinstall that panel is very awkward when putting the connector back on (only have 2 hands afterall) so what I did was bring a chair over and a box on top to hold the panel up for me. Fiddling with the outer door handle rounded off the bayonet key so I did the screw with washer trick. Hoisted the panel back on the door and popped it back on.

I still have to fiddle with this project as the central locking button nor the drivers side window switch works on the passenger door, only the controls on the passenger door itself work. Will try pulling those fuses and reseating the switch connectors to see if that "resets" and corrects the problem.

Anyways long winded post. Here's a pic of what breaks inside leaving the outer door handle useless. Pot metal piece breaks off, ugh. It's supposed to stay on that rod with the spring. Just too easy to break.

update: umm, weird, so the driver's side switch can now control the pax window no problem but still not the door lock. I didn't do anything it just started working. didn't reset the connectors yet maybe tomorrow.

Attached Images