Quote:
Originally Posted by RFaber
If youre wanting the big brakes, i would simply take the front knuckle right off, disconnect the brake caliper, abs /brake pad sensors, tension strut, lower contol arm, tie rod, and the axle, then lower the strut, and use that whole assembly, youll get a bigger wheel bearing, and all the brake stuff would fit! (need 18"+ wheels though)
Good luck!
 |
Good morning Gents,
I tried to swap the rims, everything went fine
But I have noticed that the rear rims are not same look as it was on the 4.8is
The space between the rim and car body side is very narrow
Shall I use spacers or shall I swap the suspension arrangements
Thanks