|
Xoutpost server transfer and maintenance is occurring.... |
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||
Installation of a CD Changer in a BMW X5
BMW X5 (E53) Mounting of CD Changer For E53 with or without On-Board Navigation System (SA609) E53 with Nav Hardware Kit P/N 82 11 0 009 305 E53 without Nav Hardware Kit P/N 82 11 0 009 302 Alpine CD Changer P/N 82 11 1 469 404 BMW of North America, Inc. Product & Service Engineering Dept. September 1999 GENERAL INFORMATION INTRODUCTION These installation instructions were produced to give the installation technician all necessary information to properly install the BMW CD Changer behind the left cargo area panel beginning with 2000 MY X5 (E53) vehicles. These instructions were developed by the Product and Service Engineering Department of BMW of North America, Inc. specifically for BMW vehicles and are not to be compared to any existing products for vehicles other then BMW. These instructions were complete and up to date at time of issue. Any changes in the vehicle or problems noted by the installer should be reported directly to BMW Product and Service Engineering Department. Questions regarding this installation should be directed to the BMW Technical Hotline. Read all instructions carefully before proceeding with this installation. LH (left hand) and RH (right hand) are referenced as determined from sitting in the driver's seat facing forward. Instructions dealing with a common disassembly procedure are referenced to the TIS file found on the DIS Tester. IMPORTANT NOTE Two different installation hardware kits are available for X5 vehicles equipped either with the On-Board Navigation System (Option SA609) or without. E53 vehicles with Navigation use hardware kit: P/N 82 11 0 009 305
E53 vehicles without Navigation use hardware kit: P/N 82 11 0 009 302
REQUIRED TOOLS Common hand tools CD Changer Installation 1. Remove the three shipping transport screws from CD changer. 2.Adjust the CD changer mechanism pins for proper settings. Mechanism should be set to "H" on both sides of unit for horizontal mounting position. 3. Affix the locking squares on the left and right sides of the CD changer chassis to firmly secure the pins in place. 4. Install the two CD changer brackets (2) to each side of the changer (3) with four screws (1) provided with CD changer. 5. For vehicles without navigation install front carrier bracket (2) using the two M6 nuts (6) in the vehicle and one M6xlO bolt (1) as shown. Install back carrier bracket (3) using one M6xlO bolt (1), four MS body nuts (4) andfour M5x14 bolts (5) as shown. 6. Locate audio and power cables in vehicle. Connect the three pin power & I-bus cable to changer. For vehicles without DSP HiFi connect the 6 pin audio cable to changer. For vehicles with DSP HiFi connect the single coax digital audio cable to the changer (for DSP the 6 pin audio cable need not be connected). 7. Install CD changer (7) to the carrier brackets using four MS body nuts (4) and four M5xl 4 bolts (5). 8. Installation complete, verify proper operation of CD changer. |
Sponsored Links | |
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
|