|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
02-06-2009, 08:50 PM
|
|||
|
|||
|
Service Engine Soon
I have only had my 2004 X3 for a few months. Had my oil changed the other day and then got gas. Then the Service Engine Soon light came on and will not go away. Vehicle is not running any different, any suggestions? 
|
| Sponsored Links | |
|
|
|
|
#2
02-07-2009, 12:30 AM
|
||||
|
||||
|
Likely that the gas cap is not on properly, or that it was put on after the key was turned back on. The fault light in that case is that the evaporative emission control system (which captures gasoline vapours) thinks there is a leak.
With the key off, take the gas cap off and put it back on tightly. Then drive normally; if that was it the light will go off within a day or so.
__________________
2007 X3 3.0si, 6 MT, Premium, White Retired: 2008 535i, 6 MT, M Sport, Premium, Space Grey 2003 X5 3.0 Steptronic, Premium, Titanium Silver 2002 325xi 5 MT, Steel Grey 2004 Z4 3.0 Premium, Sport, SMG, Maldives Blue
|
|
#3
02-07-2009, 12:53 AM
|
|||
|
|||
|
Yeah that is what I thought it was. I tried it and even filled up again today. I will wait a day or so and see, then I guess get a meter and run a test. Had a run in with the dealer...They screwed me with the warranty...Thanks
|
|
#4
02-07-2009, 04:07 PM
|
|||
|
|||
|
I had the same thing after an oil change. My problem was they BMW forgot to reset it to 25k until next service...
|
|
#5
02-18-2009, 08:04 PM
|
|||
|
|||
|
You might need to get your gas checked for how much alcohol is in your gas. I had the light come on, took to dealer, they tested gas and it had 16% alcohol. Don't know where my wife got gas but you need to look for signs saying they don't use more then 10% enthanal. Dealer reset the light/computer and now we make sure we only get gas at a select few locations. We are also using 91 oct or higher, dealer said we didn't have to when we were looking to buy but now we know. $130/hr labor to test and reset computer, bad gas is not under warranty.
|
|
#6
02-18-2009, 08:16 PM
|
||||
|
||||
|
:xoutpost:
Get a code scanner and forget the guess work. I use a Peak Research R5/FCX-3-16. It's about $150. 
Last edited by zerochief; 02-18-2009 at 08:21 PM. Reason: added welcome icon
|
|
#7
02-19-2009, 10:12 AM
|
|||
|
|||
|
I was thinking of getting the same code scanner but was waiting to see if the light came back on, in my case. The dealer also had an issue with me installing a K&N air filter so they replaced it when they test the gas and reset the light. K&N guarantees their filter so I open a claim with them. I ran the X3 for 5 weeks using good gas and factory filter then put the K&N filter back in. It's been over 8 weeks now and the light is still off. K&N said they would pay my bill and refund the filter cost if it made the service engine soon light come back on.
|
|
| Bookmarks |
|
|
|
|
Linear Mode
