|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Rear Windshield Wiper Replacement
(For a 2005 X3) How do I remove my rear wiper blade so I can replace it? (This may be a lot simpler than I think; I just tried changing it in the dark and it was impossible for me) Thanks! |
| Sponsored Links | |
|
|
|
|
#2
|
|||
|
|||
|
Yes, it's not like any other blade you encounter.
With the arm pulled away and pointing toward you, flip the blade so that the wiping edge is against your chest. Then with your left hand pull the blade to the left (no spring to depress). It will be difficult as it is likely gummed up with dirt, but if you are pulling in the correct plane, it will just slide off. Then you can see how simple the attachment mechanism is. Putting it back on should be a breeze, but you have to again push in the correct direction to make it seat properly (no reassuring clicks like on front wiper blades). Doesn't look like you can just refill the rubber unless you were very innovative, so probably a dealer-only part. |
|
#3
|
|||
|
|||
|
Thanks a bunch. After reading your instructions and seeing it in the daytime, it became quite easy.
IMO, This should be stickied to the DIY section. |
![]() |
| Bookmarks |
|
|
|
|