|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Vibration issue
|
| Sponsored Links | |
|
|
|
|
#2
|
||||
|
||||
|
Guibo or control arm my bet. Do you get any shake with gentle braking from say 60 mph to 50? If the shake goes away with trans failsafe I'm betting the front axle is cut off.
A worn CV can cause a shake like described.
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
|
#3
|
|||
|
|||
|
No shaking while braking. Picked up both front cv's today. Will put them in tomorrow along with the transfer case actuator gear and see where I end up. I'll report back.
|
|
#4
|
||||
|
||||
|
Good luck with getting left one out of the dif that's the hardest part of the job.
Keep the wheel hubs (knuckle) loose from the strut until you get the axle through the hub. That tip would have saved me 90 minutes. (I tried to get the axle through the hub far enough for the axle nut and no go for 90 minutes ; I loosened the two bolts that hold the knuckle to the strut and it shot through from the compression of the CV boot all on its own)
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
|
#5
|
|||
|
|||
|
Thanks for the tip. I'll keep that in mind.
|
|
#6
|
|||
|
|||
|
Got both front axles replaced. Looks like the vibration was being caused by water getting into the right front outer boot. All taken care of now.
|
![]() |
| Bookmarks |
|
|
|
|