|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
01-09-2020, 08:04 PM
|
||||
|
||||
|
Programming X5 KMBI/Cluster No Reverse Lights W/Manual Transmission -- SOLVED
Hello,
Been a lurker for quite some time. I'm needing some help coding my replacement cluster for a manual transmission as the original apparently died. Because the replacement used cluster is coded for an auto, the reverse lights don't come on when I shift to reverse. I used NCS expert to code the replacement cluster and still did not come to any avail. I still get the fault code for no CAN from EGS 1 from the cluster via INPA. Searching on Xoutpost, I haven't seen much info for E53s and this problem. I did see a good thread on E46 fanatics located here: https://forum.e46fanatics.com/showth...659314&page=17 (hopefully I can post this). Any help would be MUCH appreciated. I'll follow up with some screenshots with my coding. Thanks again!
__________________
2003 BMW X5 3.0i -- MT5, 3.64s final gears, H&R lowering springs, K-Mac bushing kit 2007 BMW X3 3.0Si -- MT6 Last edited by RocketyMan; 01-10-2020 at 05:33 PM. |
| Bookmarks |
|
|
|
|
Threaded Mode
