|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
03-06-2021, 12:23 PM
|
|||
|
|||
|
Post Headgasket/Bigsert compression # and codes
Good Morning,
My post headgasket, head machining, Bigsert and valve job compression numbers on a 160K mile M54... #1 172# #2 154# #3 158# #4 158# #5 158# #6 170# The compression tester is pretty old and the finger tight nature of this test is never my favorite. I did not put any oil into the cylinders during the test to check the rings (yet) Should these compression numbers be adequate to have a functioning vehicle until and if I decide to do the bottom end at a later date? I'd prefer they were a bit more even. I have not had the fuel injectors tested. The coil packs are new with 0 miles. I have to sort out the O2 sensor wiring. I'm getting random engine misfire codes on #5 and one or two others but the others are not consistent. After hearing thoughts on the compression I'll post the codes I'm getting.
__________________
2001 x5 3.0 (sold with broken motor), 1990 e30 M3, 1991 318is, 2002 325i, 2008 335i Dinan stage 3 6 speed, Last edited by ahlem; 03-06-2021 at 06:01 PM. 
|
| Bookmarks |
|
|
|
|
Threaded Mode
