Jet pump / transfer pump troubleshooting

[g300d]

Originally Posted by andrewwynn

When it first starts to fail you can get to near empty. It probably takes a couple years to work from 1/20th of a tank to 1/3 of a tank just that most often people catch it about 1/4.


Sent from my iPhone using Tapatalk

I see. Hmm, absent computing the mileage on the pump, anybtips on determining its the fuel pump or jet pump, if a visual inspection doesnt show anything?

[andrewwynn]

The only way would be measure the pressure on the return line to the jet pump. I think supposed to be 15-20 psi but that's fuzzy memory. It's easier to open the tank and disconnect the hose and activate the pump. (Hose pointing into the tank). It should spray like Fire hose.

On second thought: pull outlet hose and hook directly to a pressure gauge. I don’t know what the psi is supposed to be but significantly more than 50. 60? 70?

Sent from my iPhone using Tapatalk

[g300d]

Thanks for the suggestions Andrew!

Not been in the mood to fiddle with it lately, but will update when I do get around to it.

[80stech]

The first thing I would do is prop up the left side sender with a couple of sticks and have a look to see if there is any fuel spraying out of the jet pump feed.

After that if you can prop up the pump on the other side far enough to see if there is fuel flowing from the relief valve (on end of the third hose going back to the fuel pump well) that should give you an idea of weather or not the pump is providing enough flow for the jets.

[andrewwynn]

Have a rag handy. The spray out the o-ring went right into my phone camera as i was taking a video to show people that exact diagnostic.

That is the best way to see if the o-ring has failed though. Not difficult and instantly know.

If it's not spraying, there could be blockage in the jet pump and bypass the bump though the pressure relief valve.

That all said if your pump is old that's the prime suspect.

Old pump will push less and less force over time, the FPR hides this detail from you until the jet pump doesn't get enough flow to siphon from left to right and you get identical symptoms of jet pump failure.


Sent from my iPhone using Tapatalk

[g300d]

Thank you gents, for the additional info!

Hope to get around to this soon.

[g300d]

Well, I got the courage to test drive and observe things.

I put in half a tank and now fuel levels are ok both sides, enough to drive around. But that's to be expected.

What I did notice is it is definitely low on power. I noticed it was a bit low previously but a lot more pronounced now. Flooring it you get big time hesitation and it does not really want to go. Easing into throttle you dont get that, but still down on power.

Not a fuel supply to pump issue as when this was happening the OBC was showing fuel supply on both sides of pump and there was a lot at the fuel pump side at the time this was happening.

Does this look like the fuel pump @andrewynn?

I've honestly never had a pump soft fail on me, it always was a totally dead pump.