|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Auto headlight light flashing green.
__________________
'06 X5 3.0i - bought @143,123 miles (12/26/20) |
| Sponsored Links | |
|
|
|
|
#2
|
||||
|
||||
|
I haven't seen that on my 04. Here's what Gemini says: (maybe moisture in the system during the heavy rain?)
On a facelifted (2004–2006) BMW E53 X5 equipped with AHL (Adaptive Headlights), a blinking green LED next to the automatic headlight symbol (A) signals a system fault with the adaptive curve-lighting or automatic dynamic headlight leveling mechanism. When functioning normally, the green LED illuminates solid when automatic mode is active and the headlights are turned on by the Light/Rain sensor. When it flashes, the Light Check Module (LCM) has detected an operational fault and disabled the swivel functionality to prevent blinding oncoming traffic. What Causes the Flashing Green LED Internal Headlight Stepper Motor or Swivel Mechanism Failure: The horizontal swivel stepper motor inside one of the headlight assemblies has stripped, seized, or failed to report its zero-position. Moisture or Corrosion at the SMC (Stepper Motor Controller): Each adaptive headlight has a small SMC module mounted underneath the headlight housing. Moisture or condensation settling inside the housing frequently corrodes the SMC pins or circuit board. Ride Height / Suspension Level Sensor Fault: Sensors mounted to the front right and rear right control arms provide vehicle pitch data for dynamic leveling. Damaged sensor linkages or corroded connectors prevent initial leveling calibration. Steering Angle Sensor (LEW / SAS) Communication Loss: The adaptive curve module needs accurate steering wheel angle data via the CAN bus to calculate how much to swivel the projectors. LCM / ALC Control Module Failure: Corroded connectors or internal component failure on the Light Check Module (located in the passenger footwell) or the adaptive lighting control module. Last edited by haigha; 11-12-2026 at 12:32 PM. |
|
#3
|
|||
|
|||
|
I'll connect my Foxwell for a specific code. If internal components have failed, I'm not worried. I have a virgin headlight set to restore and install.
__________________
'06 X5 3.0i - bought @143,123 miles (12/26/20) |
|
#4
|
||||
|
||||
|
Great! I'm interested in what you find out.
Mine rarely sees rain (or use of the lights other than the DRLs which I had the dealer enable on delivery). It's a 10/03 build '04, so only has self-leveling. |
|
#5
|
|||
|
|||
|
A TopDon dongle with BMW software was used to scan the X5. No light control module codes were present. The scan must have reset something. I took the key out, waited a few moments and started it up. Sure enough, the headlights went up and down. The light also stopped flashing. The switch green light is solid. All good for now.
__________________
'06 X5 3.0i - bought @143,123 miles (12/26/20) |
|
#6
|
||||
|
||||
|
Great! My guess is that the heavy rain introduced some moisture into the system causing the flashing green light.
Hope you like the TopDon. I have one of their battery jump packs. I bought an Autel Maxi 808 BT which I used to diagnose my friend's Audi this summer and program the new battery I added. Old tablet tech but still seems to work fine. It has a miniUSB charging port, lol, I haven't seen one of those in a while. I also have a Foxwell 520 Pro which has been useful. |
|
#7
|
|||
|
|||
|
We had light rain yesterday afternoon. This morning, the blinking light returned. This time, I'll connect the Foxwell 520Pro for codes and possible directional control.
__________________
'06 X5 3.0i - bought @143,123 miles (12/26/20) |
![]() |
| Bookmarks |
|
|
|
|