Fog Lamp Bulb Replacement Help

[2002Silver4.6is]

I have searched and read all available posts including the instructions in the Articles section. I can get the trim ring off, the two screws securing the fog lamp housing come out as easy as can be....... when I try and remove the fog lamp housing it will wiggle but not come out.

The Article says "pull out with upward motion to release clip". I sat there for 20 minutes trying to get either fog lamp out. What is the trick to this????? I did not want to pull to hard. If anyone who has done this can help me out I would appreciate it!!!!!!!

[xnsf]

finally someone with the same problem i had...everybody said it was extremely easy...the trick, as i remember it, is to lift up the front part of the housing, and don't hesitate to put a little force into it

[Sweetbimmer]

Did you get the Hoen bulbs?
Just pop out the trim ring with a a small flahead screwdriver.
Then take out the 2 screws. You will have to wiggle it around and then pull it out.. good luck!!

[JayX5]

Just keep wiggling it until it pops out. That's the trick!!

[Dark BMW]

While pulling towards you, use something to force the fog light assembly up and out at the same time..
I used a screwdriver with a towel wrapped around it.

[2002Silver4.6is]

Thank you guys for the replies.... I will put your advice to the test this weekend!!!