|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
03-11-2007, 04:01 AM
|
||||
|
||||
aftermarket sub/amp, wired, not working?
Tapped into the wires from 11 and 12, and 5 and 6... hooked them into the high low converter, which then plugs into the amp via rca cables. I tried only pluggin just the 11 and 12 and just 5 and 6... but no luck. I am attached those wires to a cut rca cable. so one end can connect to the filter. But no sound, however my stock speakers sound hella lot better! lol.. also, keeps blowing the cd changer fuse. What am i doing wrong? 
|
| Sponsored Links | |
|
|
|
|
#2
03-11-2007, 05:01 AM
|
||||
|
||||
|
It is a 12 pin connector btw. All pins, except one are being used. Also should add, i have bluetooth installed (aftermarket, bmw oem). Should I be tapping into the front speakers? Or rear should work? from the wires that are tapped ( 5 and 6 or 11 and 12) i joined them to a rca (i cut off one end) then plugged the other end into the hi input rca connectors on the converter, which then goes to the amp...
grrr Last edited by tbal69; 03-11-2007 at 05:36 AM.
|
|
#3
03-11-2007, 06:12 AM
|
|||
|
|||
|
okay i have a 4.8 w/dsp and im only using i think 2 out of the wires, so i dont know if im getting all the sound, is there anything wrong, i tried tapping into the other 2 positive wires and it did not work... I have the periphirial converter hooked up to a 1000/1 JL audio amp which is connected to a 12" w7
__________________
|
|
#4
03-12-2007, 05:06 PM
|
|||
|
|||
|
bump
__________________
|
|
| Bookmarks |
|
|
|
|
Linear Mode
