Good news, bad news....

[tomwac]

The good news is that the car is scheduled for the 20st of September for a vitamine cure. The schnitzer stuff goes out and the car will be custom programmed (they replace the chip, no OBD programming) with dyno runs before and after. Normally they tune up to 260hp and 600Nm; but a little persuation and they agreed to give me 270hp and 610Nm. I'll report directly to x5world with some video of acceleration and rear smoke situation. They said that the soot will be kept to the minimum, which translates = there will be some, but not too bad
The bad news is that my ice>link died I can't get it to work and it used to work fine. It had the intermittend lock out problems, but switching the radio on and off cured it. But then after a 15 hours drive the thing is dead. Does anybody know where I can download the newest FW. I'm running currently 2.06.

[Tom G.]

Originally Posted by tomwac

The good news is that the car is scheduled for the 20st of September for a vitamine cure. The schnitzer stuff goes out and the car will be custom programmed (they replace the chip, no OBD programming) with dyno runs before and after. Normally they tune up to 260hp and 600Nm; but a little persuation and they agreed to give me 270hp and 610Nm. I'll report directly to x5world with some video of acceleration and rear smoke situation. They said that the soot will be kept to the minimum, which translates = there will be some, but not too bad
The bad news is that my ice>link died I can't get it to work and it used to work fine. It had the intermittend lock out problems, but switching the radio on and off cured it. But then after a 15 hours drive the thing is dead. Does anybody know where I can download the newest FW. I'm running currently 2.06.

Firmware is available on an as-needed basis, it is no longer available from the website. PM me the following information and I will reply with the firmware needed:

Year
Model
iPod Generation
Current ice>Link Firmware Version
Business CD or Navigation

[UCrewX5]

He is in Belgium - does that make any difference?

[Tom G.]

Originally Posted by UCrewX5

He is in Belgium - does that make any difference?

Wiring kits are different, firmware is the same.