Wiper motor transmission/linkage install help needed ...

[2002Silver4.6is]

I am doing the same job. I removed the nuts holding each wiper but they didn't want to budge. I was a bit concerned about pulling too hard as I did not want to damage the wipers.

Do they just pull off after removing the nut or am I missing something??

Any trick to removing the remove cabin air plenum chamber or it is pretty straight forward??

Thanks for the help!!!

[2002Silver4.6is]

Anyone??? There is some rain in the forcast and i would like to get my wipers up and running!!

I drove for an hour in the rain the other night and it was NOT a plesant experience....

[amacman]

the wipers are onto a splined shaft . generally you need to pull the wipers up off the window to release the spring tension that is present when they are on the window . then place fingers under part of wiper that sits on splines and apply pressure until wiper slips off shaft . take care of your fingers .
having said all that , i have no idea as to why you want to remove the wipers , if you just need new rubbers then that is easy to do .

[2002Silver4.6is]

Need to install a new wiper motor.... thanks

[amacman]

OK , photos coming up soon , probably not much use to you anyway if you can`t figure this out without help . back soon .

[2002Silver4.6is]

Awsome! Thanks...

One more favor?? Can I see the Front Wiper Removal Instructions??

Thank you so much!!!