need help window problems

bmdubbs · #1 05-02-2009, 10:34 AM

please can anyone help i am having problems with the door locks and windows. i have replaced the master window switch with a new one and nothing only the drivers door works the doors will lock but the drivers door has to be locked by key. i have tryed the key fob 1000 times light will not flash and the beep that it makes when locking the car its not making it so its a fucking mess i need some guys

Sponsored Links

Weasel · #2 05-02-2009, 11:14 AM

Did you try the key reinitialization procedure from the articles page yet?

Just read again and you may have a problem with the general module... Try doing a battery reset for a minute by removing the ground terminal. That just might do it for ya.

bmdubbs · #3 05-02-2009, 02:00 PM

:banghea d:

did that and the same problem also when locking the door with the key the other doors dont lock i have to press the button on the key to get them to lock. has anyone had this problem.

bmdubbs · #4 05-02-2009, 04:26 PM

weasel you out there need your help

bmdubbs · #5 05-04-2009, 11:52 PM

can anyone help me with this problem before i go to the dealer and sped hundreds of dollars

Weasel · #6 05-07-2009, 10:59 PM

Sorry that didn't work, but it was worth a try. I just got back in town tonight which is why I wasn't able to respond

.

So all the locks work with the remote but the drivers, and if you use the key in the drivers it doesn't affect the others as it should. Your problem is with the drivers door latch, whether it is unplugged, has bad connections in the door or door jamb, or is simply a bad part (which is most likely unfortunately).

If any work has been done to/in that door recently it may be worth a look in there, but I'd prepare myself for door latch replacement.

bmdubbs · #7 05-09-2009, 03:41 PM

i have a new door lock when i pluged it in it dident work is there a relay for the door

Weasel · #8 05-09-2009, 03:46 PM

Quote:

Originally Posted by bmdubbs

i have a new door lock when i pluged it in it dident work is there a relay for the door

It will only lock if it is latched. If you just have it plugged in to try it you would need to latch it for it to lock. But to answer the question, I believe it is lin bus operated and any relays for the central locking and windows would be internal to the general module. But there is always the possibility of a bad connection at the connector in the door jamb, blown fuse in the glovebox located fuse panel, etc. That's the beauty of the GT1 and other dealer systems is it can see lock/unlock requests and statuses through diagnostic resuests and can activate the components individually through component activation... Makes diagnosis easy.

bmdubbs · #9 05-09-2009, 03:46 PM

is there a chance that it could be the wire harness in that door

bmdubbs · #10 05-09-2009, 03:48 PM

there are no blown fuses in the glove box

Sponsored Links