Engine turns over but will not start.

[03BamaX5]

The good times keep on coming with the x5 4.4i.

One day last week the engine started running poorly again. Check engine light was blinking indicating a misfire. You could feel it too. Stopped at a stop sign and the engine died. Never to start again.

Over the past few months the following ignition has been replaced.

* Starter
* Coil Packs/Plugs
* Battery

I'm getting fuel pressure as checked by a gauge. I'm not getting any spark out of the coils. On none of them. I doubt all of the coils died at once. Also, I used a different plug not out of the car to check as well in case the plugs had fouled.

I replaced the crank position sensor in hopes it was causing it not to see when to spark. I also pulled the MAF cable and tried it.. Pulled the Throttle cable and tried it. Hoping it would do something in a fail safe mode.. **ALL** fuses have been checked.

Still no spark.

What else could it be?

ECU? I'm drawing blanks at this point and since this is the family wagon I need to get it going quick.

*Any* suggestions are appreciated.

Brandon