Front drive shaft install help

Marceltj4.6is · #1 07-13-2012, 03:31 PM

Hi,
I just finished taking apart the entire front and pulled the old shaft out of the transfer case. Trying to install the new aftermarket shaft and cannot get it all the way into the transfer case. Please help!
Thanks,
Marcel

Sponsored Links

Dark5yde · #2 07-13-2012, 03:42 PM

not to state the obvious but have you tried spinning it at all while pushing. Making sure the splines are lined up?

Marceltj4.6is · #3 07-13-2012, 04:27 PM

Yes, I have. Seems like the clip is too big. I put the old one on and still have the same issue. Going to try to align it again and see if that helps

bastereo · #4 07-13-2012, 04:28 PM

Try pointing the opening in the c clip down. Then wiggle the shaft about 20 degrees instead of turning it all the way around

Sent from my SGH-i917 using Board Express

Marceltj4.6is · #5 07-15-2012, 04:10 PM

Update: Success! I pointed the opening down and also made sure that the alignment was straight. I swift push and viola. Thanks eveyone!

Sponsored Links