E53 front bumper skid plate replicas

[Clockwork]

OK so I got an e-mail last night (,from Rick) that kind of pissed me off.
It said he did not drill the 1/4" holes in the skid plates as he wanted them delivered faster and he also forgot to include the plastic pop rivets he wanted to include. So he is refunding $5 to everyone.
I couldn't believe it after all the times he said he was going to definitely include mounting hardware.

Ok as for all the questions above, I will tell you now, you use the 5 existing screws on the absolute bottom of your bumper (it has 5 screws holding bumper to metal frame so you remove the 5 and put skid plate on and then reinsert the ,5 screws).
For the top three, I just bought the 3 of the same size (8mm) screws from BMW and screwed right into bumper to hold in place. I did not use the thin strip of 3m tape as it is useless.

Guys I am sooooooo sorry to hear these plates came with no hardware Or pre-drilled holes as that is how they were described to me a show they would show up to you. I wish I had of known as I would have told him to wait another day and drill them before shipping and in his rush he also forgot to tape the fasteners to the underside of the skid plates.
I just hope you guys like the build quality.

the following pic is what Rick had purchased and was going to include.
I honestly recommend drilling a very small pilot hole and then screwing in the three 8mm screws (with washers built into the screw) to hold the top of the skid plate securely to the front bumper.