Window reset?

[sneaky0]

Anyone know how to reset the window auto close? I recently changed my battery, now the auto close doesn't work.

Tia

[gatojurko]

Reset for windows? Check fuse first... auto close you mean while holding key button?

Sent from my SM-G900F using Tapatalk

[sneaky0]

The window opens and closes fine, so don't think the fuse is out.

I can "one-touch" open the window but can't "one-touch" close it. It needs to be closed holding the window button. I've seen other models needing a window "calibration" after the battery has been disconnected. For example, holding the button for x amount of time then holding it again for x amount.

Wondering how to do it for the e70.

[Qsilver7]

Info below was copied from the new BMW TIS website: https://www.newtis.info/tisv2/a/en/e...window/PU44fyK


67 62 ...Notes on initialising power window unit in front door

Warning!
Risk of injury!
There is no anti-trapping protection during initialisation.


An initialisation must be performed:

• In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible
• After the power window drive has been replaced
• After work is carried out on the power window mechanism
• If necessary, after an open circuit, e.g. disconnection of the battery or disconnection of the power supply to the door
• After the door window glass has been removed and installed or replaced
• After adjustment work on the door window glass
• After adjustment work on the convertible top
• After replacement of seals

initialisation is performed on the power window switch of the relevant door.
Requirements for correct initialisation:

• Terminal ”R” activated
• Doors and windows closed
• Sufficient battery voltage; connect charger if necessary

Initialisation comprises:

• Erasure of initialisation
• Reinitialisation

Erasure of initialisation:

• Open side window fully
• Actuate power window switch in ”Open” position (second switch position) and hold down for between 15 and 20 seconds

This clears initialisation of the power window. Anti-trapping protection and one-touch control (toll) function are inactive.
Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.

Re-initialisation:

• Close door window completely
• After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in ”Close” position (second switch position)
• Open door window glass fully
• After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in ”Open” position (second switch position)
• Close door window completely
• After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in ”Close” position (second switch position)

This completes initialisation.
Note:
Carry out function check (one-touch control function, anti-trapping protection and, if necessary, comfort function).

Note:
The power window can also be initialised in the BMW diagnosis system by means of a diagnosis job.

[gatojurko]

I have this function already

Sent from my SM-G900F using Tapatalk

[Price]

Originally Posted by sneaky0

Anyone know how to reset the window auto close? I recently changed my battery, now the auto close doesn't work.

Tia

Push and hold the button till the window goes all the way down. Release after a sec or so. Then pull and hold till it reaches the top, release after a sec. Done.