|
Xoutpost server transfer and maintenance is occurring.... |
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
xDrive50i, P0641, and misfires...
Recently got a misfire code for cylinder #7. Coil and plug were replaced. Following that there was a rough idle and a few miles down the road it started shuttering again. Ended up with codes for cylinder #5 misfire (P0305), Bank #1 too rich (P0172), and sensor reference voltage A circuit/open (P0641). Swapped the #5 coil/plug (suspected bad) to cylinder #7 (just replaced/known good), cleared the codes and fired it up. Now I'm sitting with cylinder #5 misfire and cylinder #6 misfire. Didn't let it run very long or it may have gotten the P0641 again, I'm not sure. In any case, the fault did not follow the plug/coil so I am doubting that it is the problem. Other items that may be of note. The short term fuel trim on Bank 1 is way higher than Bank 2 (20-25% vice -3%) and the Bank 1 cat temps were 200-300F cooler than Bank 2. Thoughts? |
Sponsored Links | |
|
#2
|
|||
|
|||
You may have a faulty injector dumpign fuel into one cylinder; whacking out the AFR; washing the cylinder walls; diluting the oil with fuel. Its the fatal flaw of the recent bmw v8s
When was your motor relaced? Why? Any reason to suspect it has the older, flawed injectors? |
#3
|
|||
|
|||
Motor was replaced two years ago because of a mechanical failure. Think sounds of mechanical carnage. I would be willing to be the original injectors are still installed. They didn’t replace coils so I doubt they replaced injectors
|
#4
|
|||
|
|||
Is the short term fuel trim measuring fuel flow or ECU requested fuel supply?
|
Bookmarks |
Tags |
p0641 |
Thread Tools | |
Display Modes | |
|
|
|