FS: 4.4 Full Exhaust w. 4.6 Tips Welded On
 

This is my 4.4 exhaust, which I had OEM 4.6 tips welded on there, the first shop who installed this messed it up but luckily another shop was able to straighten the tips out to make it look even.

I couldn't get the best picture, if you look close up to the exhaust you can see the weld job was kind of messy, other than that the exhaust is fine..works/runs great..if your looking for tips only maybe you can salvage it.

I don't know what price to start this out with so please send me offers, either pm me or email me at [email protected] .... I'm in socal (Encino)....oh and reason for selling is because I ordered the full 4.6 exhaust already, I'm just too picky w. the weld job even tho you can't tell really unless close up

$100?

not exactly what i had in mind

Hey FGI -

Don't recall what the 4.6 exhausts run, but I believe it was up there in price.

Have you considered going with the Dinan exhaust and 4.6 tips.
All ya need is a good welder but I think this is a better setup for the money.......

:D Looks great :D

the 4.6 was around $1300, honestly i haven't looked into the dinan exhaust but anyways it's too late as i already ordered the 4.6 exhaust, thanks anyways!

Haha, this will cover the shipping cost. Bump for a nice set of exhaust and even nicer tips.:thumbup:

if hes not using the tips anymore why sell it in its original price?just get rid of it! :D :dunno: anyways gudluck ! :thumbup:

$1300 ...the Dinan with new tips should run ya about $200 more.
Can't say for sure but I think if you wanted to go the OEM route.....maybe the 4.8 full exhaust would have been better. It's a bit more agressive than the 4.6

It's the holidays. Check to see if it's shipped....If not, u still have options :dunno:

Will this fit a 3.0?