Remove DSP

[Mark S.]

Just wondering if anyone has removed their dsp from their x5. If so, what was involved? thanks in advance, mark

[UCrewX5]

At a minimum you would need to remove the DSP amp (located down below where the CD changer is mounted) and replace it with the non-DSP amp. You would lose the rear sub that's in the back.

Mark from Tucson went from non-DSP to DSP (see http://www.xoutpost.com/articles.php?...cle&artid=160), so going the opposite direction should in theory be possible.

[el_duderino]

I believe non-DSP systems have fewer speakers... so what exactly are you trying to do? What's your goal?

[Mark S.]

i am planning on installing aftermarket amplifiers and i do not want the dsp in the loop since it is just another source for noise.

mark

[el_duderino]

Originally Posted by Mark S.

i am planning on installing aftermarket amplifiers and i do not want the dsp in the loop since it is just another source for noise.

mark

Have you seen a schematic of the system yet? The DSP processing is all internal to the OEM amp. If you are bypassing the OEM amp, you are bypassing the digital processing.

It seems that for many years the DSP systems worked with an analog signal into the amp and a digital signal into the amp from the CD changer.

BUT... the 2005 X5 I upgraded a few weeks ago had DSP, and the HU output to the OEM amp was FIXED in level, and there was no digital coax from the CDC to the amp. The volume and fader changes occured inside the amp. The balance and EQ settings were affecting the signal from the HU.

Have you read http://www.xoutpost.com/showthread.php?t=3896 ?

What year is the vehicle, and what exactly are you planning on doing to it? You might have volume control issues to solve.

[TJJ]

Head unit output to the DSP amp has always been fixed level. But if you remove the DSP, and disconnect battery for a few minutes, the HU goes to regular mode where output is variable so adding amplifiers is easy. You will lose EQ and echo effects but bass, treble, fader and balance will work, now the head unit controls and adjusts them.

[el_duderino]

Originally Posted by TJJ

Head unit output to the DSP amp has always been fixed level. But if you remove the DSP, and disconnect battery for a few minutes, the HU goes to regular mode where output is variable so adding amplifiers is easy. You will lose EQ and echo effects but bass, treble, fader and balance will work, now the head unit controls and adjusts them.

The 2005 X5 4.8is I worked on had only L and R outputs to the amp.

There is no way that the HU fader could possibly work on a two-channel system. Nothing to fade.

I have seen other cars where unplugging the OEM amp caused the output to change from fixed to constant. I'm not too excited about disconnecting the battery to test this suggestion, though.

What year and model are you describing?

[somewhereinla]

I believe the number of speakers to be the same minus the sub.

[Tom G.]

There are specific aftermarket DSP amps as well, el_duderino should be able to assist in this area.

[el_duderino]

I have seen the list and I've read many of Bob H's posts, but since the newest of these is 5 years old, I did not choose to apply most of that data to current MY vehicles.

If you CAN get a variable full-range line out of the X5 HU, janix is going to excrete a Miata.