icelink plus and dsp wiring diagram?

hayaku · #1 11-16-2005, 04:45 PM

i don't remember seeing it in the box but will check when i get home tonight... anyone got a quick diagram to share for now?

i have an 02 x5 4.4 with nav, dsp, and the cd changer... tom g sent me the icelink and cable already..

i'm ready to install it tonight but wanted to make sure i have all the parts, especially if i need to tap power...

i'll put together a diy for those interested since i can't seem to find one with all the diagrams yet..

Sponsored Links

Tom G. · #2 11-16-2005, 08:06 PM

Quote:

Originally Posted by hayaku

i don't remember seeing it in the box but will check when i get home tonight... anyone got a quick diagram to share for now?

i have an 02 x5 4.4 with nav, dsp, and the cd changer... tom g sent me the icelink and cable already..

i'm ready to install it tonight but wanted to make sure i have all the parts, especially if i need to tap power...

i'll put together a diy for those interested since i can't seem to find one with all the diagrams yet..

Email me directly and I will be happy to send out the supplement sheet.

hayaku · #3 11-17-2005, 03:52 AM

tom, its me adam...

i plug it in and everything works... no 12volt splicing thingamingy needed... the cable you sent me had the 6 and 3 pin connectors that plugged into the cd changer harness... thats all that was needed...

thanks again.. all is good =)

dannyboy · #4 11-17-2005, 06:30 AM

Quote:

Originally Posted by hayaku

tom, its me adam...

i plug it in and everything works... no 12volt splicing thingamingy needed... the cable you sent me had the 6 and 3 pin connectors that plugged into the cd changer harness... thats all that was needed...

thanks again.. all is good =)

yes its simple plug and play...a very install, can de done in minutes.

mtd · #5 11-17-2005, 02:04 PM

Tom,
there is a power connection that is on the DSP amp itself. Can we tap that for the 12v supply. Also, is that power source continuosly on?

Tom G. · #6 11-17-2005, 06:56 PM

Quote:

Originally Posted by mtd

Tom,
there is a power connection that is on the DSP amp itself. Can we tap that for the 12v supply. Also, is that power source continuosly on?

Depends on the X5, later models offered the feature of using the radio without the key in the ignition. Here's a picture of the wire I use:

This provides an always-on condition, I believe the purple wire is a switched 12V, you should verify with a multimeter to be sure.

Sponsored Links