Ok i already know the procedure for the BMW MK3 system. Nothing there about a procedure for a RR MK3 system so i will follow the BMW instructions.

What a nightmare - just tried your disk Dodi and it froze the unit. Wouldnt even eject the CD. So i had to dismantle it, get the CD out manually, burn a new copy and insert it manually, then put the unit back together and it started the update.

However it still has the RR logo :(

Any thoughts?

I can see the usw3_load is changed in LROC01O , but the LROC02O is unchanged.

I can change it myself (to the logo attached), but dont know how to create a MODE2/FORM1 image :(

POST LINK

Thanks for that - i basically dragged all the files/folders out the image you made me, change the LROCO20 usw3_load files, and then created a mode2/form1 image with imgburn - was a lot easier that way (used to use UltraISO to create the image

Will this work?


EDIT** Burnt a new image and put it into RR MK3 drive, after 10 seconds it ejects the disc again. Is this because the version hasn't changed?

I am searching for Navi-firmware for MG ROVER YIB 000160.
 

I am searching for Navi-firmware for MG ROVER YIB 000160.


http://www4.pic-upload.de/11.02.10/4sr9gd8zhjd3.jpg



http://www4.pic-upload.de/11.02.10/dy2l3qg16o1.jpg



The navi-computer also works with a 16:9 screen, so it has to be MK3.
It won't accept the Land Rover/BMW Software.

Can somebody help?

Ok the image you sent me with some pictures changed loaded fine but didn't get rid of the LR logo.

I modded it further, but the nav unit just ejects the disc after 10 seconds.

I tried modifying all the sw_rel.tbl and lng_rel.tbl files on the disk (about 32 in total in all directories) to force a new load but it sill wont accept it.

Any ideas?

Dodi - Any ideas?

Uploading.....

Great :thumbup:

What changes have you made to this one?

SECRET!!! ;)

Change:

- software version
- op.logo

Here is a new version: LINK (I hope it will be good)