Backup camera pulsates - Help
I just installed Navtool and Boyo backup camera in my '05 X5 with factory Nav. Everything works fine with ignition on (camera kicks on when I shift into reverse) but when I start the engine and shift into reverse the camera stays on for a second or two then switches back and forth to the nav screen... I can't seem to figure out what is different with the ignition on vs. turning the engine on... I installed relay as follows:
85= ground 86= reverse light trigger wire 87= Navtool video module trigger 30= switched power Any help much appreciated... Rob |
fyi.. my maddening ordeal is over... After much searching and confirming the wiring diagram I was working from was correct I started from scratch and rewired everything back up... all is working fine now... apparently user error missed or crossed a wire to the relay...
|
All times are GMT -4. The time now is 11:58 AM. |
vBulletin, Copyright 2024, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.