Forum: X5 (E53) Forum
08-20-2014, 02:01 PM
|
|
Replies: 7
Views: 1,799
|
|
Forum: X5 (E53) Forum
08-16-2014, 07:47 AM
|
|
Replies: 3
Views: 4,313
I found this and additional posts on other BMW...
I found this and additional posts on other BMW sites with the possible remedy ranging from, Bad alternator/voltage regulator, to oil soaked TCM wiring harness, speed sensor, bad transmission, to...
|
|
Forum: X5 (E53) Forum
08-15-2014, 03:54 PM
|
|
Replies: 3
Views: 4,313
P0735: Gear 5 Incorrect Ratio
P0735: Gear 5 Incorrect Ratio: 2003 3.0i with 171,200 miles
Has anyone had any experience with this code?
Three days ago was on the high way and bout 75 or 80 mph X5 went into "trans failsafe...
|
|
Forum: X5 (E53) Forum
07-18-2014, 11:00 AM
|
|
Replies: 17
Views: 3,120
|
|
Forum: X5 (E53) Forum
07-17-2014, 10:29 AM
|
|
Replies: 17
Views: 3,120
|
|
Forum: X5 (E53) Forum
06-23-2014, 11:55 AM
|
|
Replies: 22
Views: 7,406
Last month the driver side door handle carrier...
Last month the driver side door handle carrier mechanism went bad and while I waited for the replacement to arrive. my wife drove the X5 to work that day, she stopped at home to pick the kids up for...
|
|
Forum: X5 (E53) Forum
06-19-2014, 01:09 PM
|
|
Replies: 13
Views: 3,663
I cleaned mine this past week, I used the FJC...
I cleaned mine this past week, I used the FJC brand of A/C evap cleaner and odor control. I had to take off the cabin filter tape the hose from the can to a dowel rod and insert in the two openings...
|
|
Forum: X5 (E53) Forum
06-05-2014, 10:19 AM
|
|
Replies: 1
Views: 1,791
|
|
Forum: X5 (E53) Forum
05-14-2014, 04:24 PM
|
|
Replies: 5
Views: 941
if I remember when I pulled mine it located in...
if I remember when I pulled mine it located in rather snug, I think there is a boss located on on opposing corners of the mating surface, I do know it is very important to return the bolts to the...
|
|
Forum: X5 (E53) Forum
04-03-2014, 03:17 PM
|
|
Replies: 15
Views: 2,907
My 03, with 165k did something similar this...
My 03, with 165k did something similar this winter. I was backing out of my garage and she was running really rough. I immediately shut it down then tried to restart. It would crank but not fire....
|
|
Forum: X5 (E53) Forum
03-20-2014, 03:34 PM
|
|
Replies: 25
Views: 4,040
I replaced pads/rotors all the way around this...
I replaced pads/rotors all the way around this past weekend. I went with Centric Posi-quiet ceramic pads and Meyle Platinum rotors. Replaced all the hardware, slide bushings and caliper bolts. So...
|
|
Forum: X5 (E53) Forum
03-06-2014, 11:21 AM
|
|
Replies: 12
Views: 2,436
|
|
Forum: X5 (E53) Forum
11-15-2013, 07:54 AM
|
|
Replies: 5
Views: 2,260
I replaced the Oil filter housing gasket about...
I replaced the Oil filter housing gasket about 600 miles ago but nothing down that low.
I pushed it back on, filled and bleed the system got it back to operating temp and no leaking I will get...
|
|
Forum: X5 (E53) Forum
11-14-2013, 04:54 PM
|
|
Replies: 5
Views: 2,260
Heat exchanger came loose
Has anyone experience the Heat Exchanger coming detached from the radiator?
I was a few houses from my driveway and the "check coolant level" came on, I know I had some weeping around the o-ring...
|
|
Forum: X5 (E53) Forum
10-28-2013, 03:24 PM
|
|
Replies: 4
Views: 1,108
|
|
Forum: X5 (E53) Forum
10-28-2013, 03:23 PM
|
|
Replies: 4
Views: 1,108
|
|
Forum: X5 (E53) Forum
10-28-2013, 12:55 PM
|
|
Replies: 4
Views: 1,108
Oil filter housing Gasket and What I learned
Changed the oil filter housing gasket this weekend. I learned a few things;
after 163,000 plus miles the gasket becomes rock hard
disconnect the banjo bolt for the oil feed line to the...
|
