how to fix the dcs indicator??
 

hello all...i have problem with my dcs indicator in my x3 2005....after i install the car audio...my dcs indicator always on and i can not turn it off with the dcs switch ( the dcs switch can't function ) and activate the dcs system...what is the problem?? can anybody help me with this issue??:(:(

thank's in advance.....

I'm guessing you mean DSC (dynamic stability control) :D

The light comes on when there is a fault in the system just like the check engine light, but can not be read by just any scanner as it is the stability control system.

Did you cut/splice or tap into any wires in your install that may have been for that system? What I would do first is go somewhere (dealer or independent with GT1 tester) and have the faults read and analyzed. It may even just be coincidence that the fault occurred after the install, but it may be related. BMW's have some complicated and sophisticated wiring that is very picky. (most things run on shared wires through can-bus signals)

ic ic...thank you weaser...yes...that is dsc...hahah sorry for confusing....the cable that i slice and cut just the front speaker cable....because i'm install the hi to low rca converter for the amp installation....tommorow i will check it again....and if i find the answer, i inform again.....if because the slice cable, do i need to reset the dsc system with analyser again for full function again or just need to fix that cable?? because in my town, do not have bmw dealer....:dunno::dunno:

The speaker cable shouldn't have anything to do with the DSC system, ouy may need to find a shop that has the BMW test equipment. Are there any decent shops for BMW in your area?

sadly to say....there is no bmw workshop in my area.....hope i will find the problem solving tommorow by my self...because the nearest bmw workshop are 700 miles away and separated by sea.....hiks hiks...