E53 air bag to coil conversion
 

I just recently installed the Suncore air bag to coil conversion w/ warning removal module. previous to conversion, the EHS system kept popping the 30A fuse # 87. i connected the warning removal module inline to the rain sensor . i also removed fuse #57 . the stupid selfleveling inac is still on . Any body ran across the situation?

subscribed. I'm considering switching to coil overs. I'm getting a sag in the front again after replacing both struts less than 2 years ago.

suncore industries ebay
 

L@@k on ebay suncore industries coil over conversion kits.

250BW-37
 

Have you figured out how to make the module eliminate the warning? I was about to order it then saw your thread and don't want to waste $350.

I figured it out .l contacted suncore Ind . they instructed me reconnect everything like original . disconnect the warning removal module.start over n reconnect the warning removal module. The only thing the message reappears when using the wipers(rainsensor).other than that its fine.

So the air suspension message comes on only when the rain sensing feature is activated or any time the wipers are activated?

rear suspinac
 

the error msg goes on when using wipers. today lo fuel lite came on & error msg rear susp inac came on. after fueling up , the error msg went away.

Wow, this is pretty costly. Does it come with instructions too? Do you still recommend it despite the wiper issue?

BMW x5 E53 2000 2006 Electronic Air Ride Suspension Warning Message Remover | eBay

Are there any alternatives?

it does come w/ instructions. i recommend it because it would cost you to dump all kinds of $ repairing the air bag components. you get factory stock height in the rear.