I was able to score a set of sport e46 power heated seats, I'll let you guys know how I make out, from what I was able to find out it should be plug and play!! I'll use the computer at work to re initialize them and I should be golden...fingers crossed!

You'll need to add in the loom (think it's only a couple of wires from memory) that controls the steering wheel position from the seat module otherwise it wont drop and raise when you first turn the ignition on nor will you be able to alter its position.

could you be more specific? Is there a how to somewhere? Wiring instructions?

Thanks!

I'm afraid not, not off the top of my head, it's been a while since I swapped mine.

However get both seats next to each other and compare the connectors that go into the seat module (the object with the seat position switches on). You'll be able to spot which ones they are. Basically there's an extra couple of wires that go from the main yellow connector under the seat to the module.

Or alternatively just swap the whole seat loom over but this is a bit excessive.

did you swap out the seat controls too or leave the e46 seats switches? Is it something obvious and easy? thanks again!

I think I did yes but I might not have needed to - think I tried both modules and they both worked providing the wires were in.

Yes it's obvious and easy.

where would those wires run to in the e46 seat? I appologize for asking so many questions, but this is what will pop up when people search in the future..

thanks again!

You don't necessarily have to do this. I have a shop in NY that didn't swap any modules over and got my sport seats to work (they came out of a front end wreck).

If you read what I've posted I've already given you the information for this.

When you actually look at the seats out the car all will come clear.

Just incase I didn't make myself clear...

Thanks! When I get them together if I have any questions I'll post up here!