INPA - cant connect to all modules FIXT
 

Ok, so I finally got a laptop with INPA and a cable.

INPA sees power and ignition on.

Trying to scan the entire car and it cant read a lot of modules.

Engine and transmision it can detect, read, and clear errors and adaptations.

Other parts of the car, not so much.

Any suggestions on where to start?

I like to use DIS vs INPA personally

I had the same problem until I soldered pins 7 and 8 together.

RB, yeah the DIS does look more comprehensive, dunno if I have it in the computer though.

Blackbeast, thanks for the tip, I will try that!

Ok, couldnt find my soldering iron so I got some bare wire and used it to bridge pin 7 and 8. Reads most of it now. Thanks blackbeast!

I do get a few "version is different" errors and a few errors here and there. Still playing around with it.

i always wonder about that but i was told the newer cables didn't need to solder pins-7/8 together maybe i'll try on mine and see.