P1093 need help
 

2006 BMW X5 3.0I
110k
Mil light is on DTC...p1093
Refreshed cooling system, NEW CCV, ALL NEW O2 sensors ...New ICV, New MAF(Bremie)

Need help...car running and idling fine... Just P1093.
Regards,
CB

Did you get this code after you replaced a part or did you start replacing parts in hope of getting rid of this code? Using OE parts or cheap aftermarket crap from eBay or Amazon?

Thank you for your reply...

I had 1093 prior to 100k maintenance...I did...I was surprise my cooling system pump and thermostat lasted this long...plugs are NGK ...coils and O2 are all Bosch...MAF is Bremi...all cooling parts OEM
Belts are Conti...did Valve cover gasket and CCV ...removed intake all new gaskets and plugs OEM
car runs good...just P1903...

Any wisdom....

BMW fault code 236 decimal (EC hex) corresponds to the generic P1093. There's a technical bulletin issued by BMW for fault code 236 (P1093).

Here's the bulletin. Unless you know how to update the DME and have the correct update, maybe it's time to bring it in.

chrome-extension://oemmndcbldboiebfnladdacbdfmadadm/http://www.bimmerfest.com/forums/attachment.php?attachmentid=576546&d=1474205253

Thank you sir...I heard about it. I will look in to it. I Believe that was published around 2003???

Can you post Freeze Frame info for the P1093 code?

Log files might also be useful.

If you are using OBDFusion, also run and post a Diagnostic Report for review.

e-mailed to your Gmail.
Thank you .