![]() |
Did I leaves something disconnected?
My 3.0 won’t complete the OBDii diagnostic cycle to pass emissions in GA. It completes 7 of 8 cycles but after nearly 400 miles, numerous starts, all types of driving I still get the catalyst monitor incomplete but no codes. Last month a got a bank one before catalyst check engine error but I cleared it and reset the adaptations.
As a senior I am exempt from exemptions but if I tried to sell it would need to pass. This car had a shade tree head gasket done 1200 miles ago, is it possible I left something disconnected or have one of the O2’s reversed in their places causing it not to complete the diagnostic cycle? Thanks. Sent from my iPad using Tapatalk |
Quote:
|
Lambda Sensor = O2sensor?
Sent from my iPad using Tapatalk |
Quote:
|
Thanks, sure I have the manifold sensors correct, might have crossed the Dow streams? Matter?
Confused that after 100 miles or so it would either complete the cycle or throw a code if not good. Sent from my iPad using Tapatalk |
Quote:
|
Car has 95k on it 03’. Assume original.
Sent from my iPad using Tapatalk |
Get up early tomorrow morning and get on the 85/75 or whatever highway is near you and set to the cruise control at 50 MPH for 15 minutes. DO NOT exceed 3000 RPM or go below 40 MPH or over 60 MPH or it will reset again. 15 minutes at that speed should clear the catalyst monitor.
|
Ok, Probly get on the 400 though.
Thanks Sent from my iPad using Tapatalk |
At 95K they should still be fine unless they were compromised by your head gasket issues. I don't know if you had water out the exhaust or if you dumped a lot of coolant down the exhaust when you removed your head. :dunno:
|
| All times are GMT -4. The time now is 11:56 PM. |
vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.