I'm sorry, but I failed to mention in my earlier post that I already have BMW INPA, Tool32, etc. all downloaded and installed on a laptop.

I was looking for INPA instructions on how to calibrate or reset the suspension.

Try reading through this thread....


https://xoutpost.com/bmw-sav-forums/...libration.html

Thank you for the link. Excellent info, I will try to get to it today.

Had the same inactive air suspension too today 1st time ever...only got air suspension at rear....l m gonna monitor and see, as message went away after parking turning off engine n returning a few hours later

Can anyone please shed light on what needs lubing via use of photos or diagrams when it comes to the air suspension issue?

The air spring is a big rubber “sock” that’s inverted over a big plastic tube. It makes a very sharp turn so there’s a crease. I think you have to jack the axle up to maximize extension and then spray the treatment up inside the area where it folds. I will try to do this treatment soon and take photos.

i just remove the wheel, jack up the rear from the body and then spray the airbag and then use a disposable glove to get the liquid covering the backside of the cylinder.

Okee thanks, silicon spray any good? Will be impossible get hold of the other hi tec stuff you have in the US

I've purchased ATP AT-205 from Amazon in the USA and had it shipped to NZ - wasn't even very expensive (maybe $25?).

Buggers here dont allow aersol based thing through post