![]() |
Another Angel Eye Question...
I purchased the set of angel eyes that NINCHS recommended from blackbox carputers, I proceeded with the install removed and baked the lights, installed the rings everything going well up until I wired them, I tapped them into my DRL's brown (-) gray (+) tested and no angel eyes all my lights are working Drl's work parking lights work Hid's work so whats up? Any recommendations maybe bad ballasts? hard to think both are bad but who knows.... NINCHS or anyone? any feedback would be appreciated thx in advance !! I did email the company waiting to hear back from them..
|
Quote:
|
I PM'd this too you too.
I didnt wire mine as DRLs, i just tapped them into my fogs and they lit up when i turned my fogs on. Are your DRLS turned on? your day time running lights have to be turned on by the dealer as it is a function of the ECU, so if your DRL's were not on before you wired the angel eyes, it means your DRLs are not receiving power. the kit you ordered is the same as jlevis just minus the wire harness. You can test them yourself by dropping the ballast wires down to one of your fog lights and tapping into the fog light wires. its easy to take your fogs out. just pull the trim out, then there are two screws at the bottom of the fog light housing. then a stiff pull will pull the fog light out. Hope this helps! and post some pics when you get it done! good luck! Quote:
|
Quote:
|
thx for the input gals and guys, I believe the ballasts are bad also. Oh well wait another week or so hopefully blackbox carputers will accept only the ballasts for defect I would hate to have to remove all those rings I so carefully installed :) Michelle did you have to send the ballasts back to jlevi or did he just send you a new set?
|
NINCHS to the rescue, I tapped them into my fogs and the Angel eyes turned on !! I am very impressed with these AE's considering they are less than half the $$ of the competitors. I will try and post pics soon, but I figured this site has seen far too many do it yourself AE installs
|
Quote:
|
Lesson learned is don't tap into the DRL's. The reason why is the DRL wires are not a 12 V source, rather it is reduced in voltage to make the lights dimmer then normal.
|
Yes I was not aware of the low voltage from the DRL's since the instructions had stated to tap into the DRL's. Good to know Ucrew thx
Actually NINCHS I ended up getting these AE's for $3.95 including shipping since paypal owed me some credit. The new thread should read Pics of AE's for $3.95 !! :) |
Smokin deal!
|
| All times are GMT -4. The time now is 05:19 PM. |
vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.