Xoutpost.com

Xoutpost.com (https://xoutpost.com/forums.php)
-   X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)
-   -   Replace Head Lamp Bulb (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/37541-replace-head-lamp-bulb.html)

johnqpublic99 07-09-2011 12:12 AM

Quote:

Originally Posted by george1202 (Post 376702)
I've changed xenon bulbs 3 times without any problems. What works for me is loosening the screws that attaches the headlight assembly, pulling it out slightly so you can take out the black, round plastic that covers the xenon bulb. Once you get the black cover out (this has 3 small torx screws), simply twist the bulb socket/wire (the one that connects to the ballast) to detach it from the bulb. The next step is to twist the round plastic lock that locks the bulb in place, unlock it, take off the old bulb and reverse the procedure to install the new one.. It takes me no more than 30 minutes to replace the bulbs on both sides.

Sorry to revive an old thread but just wanted to state that I followed these instructions and had the xenon bulb replaced in about 20 minutes... I've seen other threads where the airbox has to be removed, the battery disconnected, yaddiyadda... this works and works well... just wasn't sure about the possibility of an electrical discharge so I took basic precautions and it took very little time...

Thanks George.

DF

sasquatch 02-06-2012 06:37 PM

Bringing this back from the dead......I've got to replace my low beam HID lamps but I have the headlight washers on the bumper. I assume you guys do not have this option? I can pull the headlight out to a point but the washers get in the way. I really do not want to remove the bumper cover. Any suggestions?

Clockwork 02-07-2012 09:49 AM

sasquatch, sprry to say but you have to remove the bumper (super dupear easy)
check "how to's" for a diy on how to remove 04-06 bumpers. lots of little screws holding it on, but its NOT hard and really only takes 10 min to remove and re-install. just be careful of the plastic clips at the top of the bumper as it attaches by the wheel wells.

johnqpublic99 02-07-2012 11:33 AM

Quote:

Originally Posted by sasquatch (Post 865079)
Bringing this back from the dead......I've got to replace my low beam HID lamps but I have the headlight washers on the bumper. I assume you guys do not have this option? I can pull the headlight out to a point but the washers get in the way. I really do not want to remove the bumper cover. Any suggestions?

Are you saying you have the headlights sprayers? I have those and they were definitely not in the way... definitely did not have to take the bumper off. If you do have a different style of headlight washer and you have to take the bumper off, might I suggest to go in from within the engine compartment and remove the airbox and other peripherals.

DF

sasquatch 02-07-2012 02:18 PM

Quote:

Originally Posted by johnqpublic99 (Post 865191)
Are you saying you have the headlights sprayers? I have those and they were definitely not in the way... definitely did not have to take the bumper off. If you do have a different style of headlight washer and you have to take the bumper off, might I suggest to go in from within the engine compartment and remove the airbox and other peripherals.

DF

Yeah I have the four (two on each side) washer jets which sit on top of the bumper cover. I looked at it last night and figure I might be able to wiggle the headlights out if I'm careful. Those washer jets stick up about an inch.

ECS Tuning 02-07-2012 03:08 PM

^that's how I suggest people remove the headlamps also. Take it slow and they will slide out.

Quote:

Originally Posted by george1202 (Post 376814)
Get the OEM brand which I believe is Phillips D2S bulbs

Correct, also I have them available HERE.

ECS Tuning

sasquatch 02-07-2012 05:15 PM

Quote:

Originally Posted by ECS Tuning (Post 865232)
^that's how I suggest people remove the headlamps also. Take it slow and they will slide out.


Correct, also I have them available HERE.

ECS Tuning

Yeah I already got a set of Philips 85122wx lamps for pretty cheap.

Can you maybe go into the differences between the different 85122 D2S lamps?

ECS Tuning 02-07-2012 05:26 PM

Quote:

Originally Posted by sasquatch (Post 865257)
Can you maybe go into the differences between the different 85122 D2S lamps?

Looking in my product guides form Philips I'm not seeing a 85112xm so at this time I cannot comment on the difference between it and the 85122cm.

sasquatch 02-07-2012 05:53 PM

Quote:

Originally Posted by ECS Tuning (Post 865259)
Looking in my product guides form Philips I'm not seeing a 85112xm so at this time I cannot comment on the difference between it and the 85122cm.

I edited the post.......85122wx. Suppose to replace the 85122+ lamps.

And from what I've read on other forums there are fake Philips lamps being sold on places like Ebay. I bought mine from an Amazon seller who is legit but I'm beginning to question if the lamps are real Philips or not.

sasquatch 02-07-2012 08:19 PM

And check out this forum thread:

Philips 85122 CM and 85122 WX

Interesting discussion about fake Philips lamps.


All times are GMT -4. The time now is 07:49 PM.

vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.