big delay when putting in reverse
 

When i shift my car into reverse i get a big delay..almost like it is in neutral..it'll take a good 2 seconds before the gears shift into place. For instance when i'm on a hill and shift it into reverse, my car will roll down the hill before it catches..

is this just a programming issue or a real transmission issue?
i still have CPO but my dealer always just shrugs this problem off

Take it to another dealer! From reading other posts over the years this is usually the start of the tranny going south.
Check with Weasel he should know.

i guess at this point i'm hoping for my trans to crap on me before my warranty is up!

I would seek advice and make sure it dies under CPO!! ;);)

It could be as simple as programming and/or resetting adaptations, could be hydrolic pressure dropping at idle causing slow reaction, could be slow moving valves/solenoids, etc. etc. etc.

It would take bringing it in to the dealer under CPO for it again, and saying you've brought it in for that a few times and no one really spent much time diagnosing it yet. Maybe have the shop forman get in it with you and show him personality what it's doing to make sure it isn't blown off and get the ball rolling.

will do... thanks:2thumbs:

transmission is gone- mine just did not give any heads up - one day when I went to take it out of the garage the reverse did not engage at all - at least you are getting some kind of message before it goes bad

dealership says theres nothing wrong. i even talked to the shop manager..

i just hope it goes before cpo is up.. maybe i'll bust on my tranny haha

This is how mine went - 1 day a 2 second delay the next no reverse

so i really better get on it then...they really are just shruggin it off...

theres no way to convince them theres something wrong..how do i approach this again?