Xoutpost.com

Xoutpost.com (https://xoutpost.com/forums.php)
-   X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)
-   -   02 X5 cant get rear door panel off need help (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/66856-02-x5-cant-get-rear-door-panel-off-need-help.html)

f16driver 10-25-2009 05:16 PM

02 X5 cant get rear door panel off need help
 
My right rear window stopped working yesterday while in the down position. I hear the motor working but maybe my cable is broken or a plastric piece. I wont know till I get inside the door to look. I've been able to remove the trim panel, the 3 torx screws, the lower door light, the cable that connects to the door handle, the window switch and all the side and bottom plastic plugs holding the door cover on. My manual says there should be another screw located under the door handle and only visible when the cable to the handle has been removed(maybe thats just on the front door). I dont see another screw. I'm also having trouble getting the rear shade off. I can't feel or see any tab inside the upper slot that needs pushing. As best I can tell, I have to remove the shade before I can get the door cover off. Do I need to remove the door handle?I know about the LED light in the handle. After all the above is done, I'm trying to figure out how to get the door cover off the top of the door. Should I just push up on the door cover to get the clips to release across the top? Is it necessary to pry up the outside window trim? What tool do you use to release the clips?
This is my first window problem, 120K, so based on what I've read, I'm overdue. I did read most of the DIY articles.

Thanks,
F16driver
2002 4.6is

X Foomph 10-25-2009 08:33 PM

Hey there F16,
I've removed my front door panels several times for the dreaded regulator prob however the rear windows are hanging in there, at present. When and if they do let go I'm going to revisit this very helpful video:
http://www.youtube.com/watch?v=y25x6gIIgPE

Quote: I'm trying to figure out how to get the door cover off the top of the door. Should I just push up on the door cover to get the clips to release across the top?

Once you have all screws, light fitting released etc and wires unplugged, my understanding is that you start from the bottom by giving it a short quick tug (carefully) then as you 'pop' the remaining plugs it will simply lift up and off. All explained in the vid.

Here's another link from some time ago: The Zotosphere: X5 Window Repair

GL :thumbup:

f16driver 10-26-2009 05:46 AM

GL,
That video link is just what the doctor ordered.
Thanks,

F16Driver


All times are GMT -4. The time now is 06:32 PM.

vBulletin, Copyright 2025, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.