| RenaissanceMan |
09-29-2011 05:58 PM |
Quote:
Originally Posted by 1stE53
(Post 845387)
Since you have to drive it. You may end up damaging the bearings. They don't instantlly become ruined once the grease is out though. I know this because I have an aftermarket Axle that does not fit properly and the inside boot cllip got knocked off and al the grease leaked out. It has been over a week now. I ordered a proper axle to replace it, but it has not arrived. I noticed my original one went bad because when I put the car in reverse it clicked a bit. I got under the car and could move, slightly, the axle. It was not completely solit with NO play like it should. If it is still OK then you can get away with a new boot. What I have found though, you better do this yourself. All the cost is labor. You can get an OE BMW boot from the dealership for under $40. Labor is a BIATCH :yikes:. I did it though. 4 hours. Now that I know how to do it, I should be able to replace the aftermarket axle with the new one in about 2 hours. One thing is for sure, I will use 2 pry bars. Those solit as hell ones that construction workers use to take appart 2X4s from walls.
Just stay away from sharp turns and WATER. Should be ok for short short time.
|
Sorry, I should have been more specific... I'm actually planning on taking it in to get it repaired first thing in the morning so that I don't have to drive it to the track on the torn boot. I believe the tear is very recent... Had the indie tech look at it today and he felt I'd be safe to do the boot only. Like I said, I HATE to spend that much on the labor, but I don't want to have to worry driving this thing tomorrow afternoon. Thanks for the feedback. Will definitely do the next one, myself.
|