Xoutpost.com

Xoutpost.com (https://xoutpost.com/forums.php)
-   X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)
-   -   Trunklid Rattle? (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/73658-trunklid-rattle.html)

zzzzkev 06-12-2010 10:44 PM

Trunklid Rattle?
 
Over bumps, rough road, and anything that causes minor body roll, the top part of the trunklid rattles where it mates with the bottom portion of the latch. I have adjusted the rubber mounts on the frame, I have taken off the tunklid trim and tightened what little play there was on the lower mating portion of the latch (the female piece). No luck...still rattles. :( Anybody have this happen and more importantly HAVE A CURE?
2002 3.0 147,000 miles.

Naz24 06-12-2010 10:48 PM

i've seen people put a little layer of felt or somehhing on those tabs

MINIz guy 06-13-2010 11:45 AM

I have felt on the rubber stoppers and felt on the latch mechanism. What I mean by that is the part that clicks into the bottom tailgate, the metal part that sticks out from the top tailgate, is covered in felt. One last thing I did was add more felt to the little plastic trap door on the bottom tailgate. When you look at the bottom tailgate close, there is a little plastic door that slides up and down it. I realized that that door didn't have enough padding and would vibrate over bumps. Right now, our X5's trunk is completely silent.

papasmurf 06-13-2010 11:50 AM

Replace the trunk stoppers with the ones that are sprung, and replace the rubber stoppers on the lid itself. I did the trunk stoppers, and it stopped it for a little bit, but then I realized from 8 years of rattling that the rubber on the hatch had compressed significantly (you can see the imprint of the torx screw on each one), so I need to swap those.

zzzzkev 06-13-2010 08:15 PM

Quote:

Originally Posted by papasmurf (Post 748519)
Replace the trunk stoppers with the ones that are sprung, and replace the rubber stoppers on the lid itself. I did the trunk stoppers, and it stopped it for a little bit, but then I realized from 8 years of rattling that the rubber on the hatch had compressed significantly (you can see the imprint of the torx screw on each one), so I need to swap those.

I have the torx screw imprints in the top trunk lid part (the two extensions that hold the lid up). Anybody have a part # for the upper extensions and the rubber bushings with the torx screws?

amacman 06-13-2010 08:22 PM

item 35 or 36
RealOEM.com BMW E53 X5 4.4i TRUNK LID/REAR WINDOW


All times are GMT -4. The time now is 11:14 AM.

vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.